This Wallet Closure sits on the top edges of a wallet/purse, the back on one side and the front (with hole) on the other. Pull them together and push the flip part through the hole to securely close the wallet/purse. They are prepackaged and come with 10 screws (8 are needed, 2 are extra). Each bar has protective plastic that needs to be removed during installation.
These bar closures are open on each end so they can be used on wallets and bag flaps that are also wider than 4.5″ wide. They are not closed at the ends, which would limit them on only 4.5″ wallets, you can use them on larger sizes and also bag flaps.
Frame size: 11cm (4-1/2 inch)
Pack: 1pk
Instructions:
Follow the directions in your particular pattern OR Slide the channels down on to the finished edges of your completed wallet to test fit. Mark holes and if using heavy fabric, poke holes with an awl to allow the screws to enter easily. You will need to cut the opening for the clasp and if desired finish those edges by doing a quick hand or machine basting stitch around them, zig-zag or over cast stitch. Use a small amount of glue in each channel, slide on and insert screws with a mini phillips head screwdriver.
